Post your ideas, suggestions and support issues here.
Post Reply
jimward
  • Posts:
  • Joined:
    Wed Oct 23, 2013 7:25 pm

I have A little shop and offer a variety of services one of which is light welding. Thanks for all the vids, very helpful.
For some time now I have had an idea for my dream welding machine, alas I have not seen it out of any of the manufactures out there.
As you have contact with a lot of them, I thought I would run it by you. If you find the idea worthy, please run it by them.
I would like an all in one machine that will stick, tig, mig and plasma cut.
All processes, s.s. alm. low carbon, ect.
I would like it to use full size spools for mig. I would like it to cold roll off the mig spool for tig. I would like fetures like high frek start, read outs in percent, switch between electrode positive and negitive by switch on the control panle.
I would like pulse, dig, inpedance and all the other bells and whisles. Flux core or gas or both.
I would like 100% duty cycle and all processes good to one inch.
Not cheep, I know. I can handle whatever rolls in... Priceless.

Please add to the dream machine any Ideas you may have.
All in one and one for all ! Bad pun, sorry.
Mike
  • Posts:
  • Joined:
    Mon Dec 06, 2010 1:09 pm
  • Location:
    Andover, Ohio

Welcome to the forum Jim.
M J Mauer Andover, Ohio

Linoln A/C 225
Everlast PA 200
jimward
  • Posts:
  • Joined:
    Wed Oct 23, 2013 7:25 pm

Thanks Mike,
Good to be here!
User avatar
  • Posts:
  • Joined:
    Wed Oct 23, 2013 3:30 pm
  • Location:
    Palmer AK

Miller XMT 450 MPA ... Mig Feeder and Tig Pulser http://WWW.MillerWelds.com ;) bring your wallet :lol:
You'll have to buy a separate plazma cutter though
Just a couple welders and a couple of big hammers and torches.

Men in dirty jeans built this country, while men in clean suits have destroyed it.
Trump/Carson 2016-2024
Post Reply