Welding Tips and Tricks

Other than 'hovering' the mouse over a thread to see a short bit about it, I would leave things alone. Change for improvement is fine, change for the sake of change is not. Plus, new progs are never right at the begining, and not for a long while after. These 'programmers' see it as "Theres always room for improvement", if theres no bugs to work out, there goes the job.

Leave things alone!

-c-

Some may have forgotten, and the newer guys never saw it, but we did go through an upgrade here, about three years ago if I recall.

At that point, Jody's son came on board as the webmaster, and he is a programmer, who slowly tweaks the forum as it needs it.

I'm so new here that I hope you leave it as it is at least long enough for me to learn my way around.

I'm with another forum on a different subject that just changed their software... not only did a lot of data not make the change the whole 'feel' of the site was lost.

You can't make changes and have it remain the same.

I'll throw my 2 cents in and leave it be. I like what we have and wouldn't want to see it change except for what is needed and those changes should be slow. There is so much info on here is would be terrible to loose the knowledge stored here. I often search here for info I have put here as well as from others.

With that said, I for one appreciate the suggestion for sure. We will see what happens I guess.
-Jonathan

I don't see anything that needs changed.

The newer forums are nice because they allow much better monetization , information gathering for marketing and better integration of Ad's within whatever page you are viewing. I prefer forums like that. Thumpertalk is a good example .

Monetizeation for information defeats the purpose of this forum.

haha my post was said jokingly .

I agree with superior welding.