Welding Tips and Tricks

Good stuff!

It's been a while, but I've done all of this except the open-root on ceramic (though I've done it since with E308 hard wire in both short-circuit and spray).

I did pick up a great tip that I'm stunned never occurred to me on my own... cone-grinding the end of a liner for centering and optimum contact. I'll be doing this at liner and/or diffuser changes from now on.

Great set of tips, and good troubleshooting guide.

Steve S

ESAB correspondance curse

Very complete with a good interactive interface

Works on cell phones

http://www.esabna.com/euweb/awtc/lesson1_1.htm

We are not allowed to curse on this forum otherwise we might get drama from Otto.
No wait - he's already gone all dramatic!

Coldman wrote:We are not allowed to curse on this forum otherwise we might get drama from Otto.
No wait - he's already gone all dramatic!

I see what you did there

Well I'm not as eloquent as exie but in his absence we must mold clay such as we have even if he be the veriest varlet that ever chewed with a tooth.


Sent using Tapatalk

Coldman wrote:Well I'm not as eloquent as exie but in his absence we must mold clay such as we have even if he be the veriest varlet that ever chewed with a tooth.
Sent using Tapatalk

Now that is quite the...expression I'm trying to conjure an image in my mind but it eludes me

Google enlightens all


Sent using Tapatalk