It is currently Tue May 23, 2017 10:48 am Advanced search

Grinding

General welding questions that dont fit in TIG, MIG, Stick, or Certification etc.

Grinding

Postby Mike926443 » Sun May 14, 2017 6:18 pm

Hey guys bit of a noob question here. I was using a cutting wheel to grind clean a hole I just drilled. I gashed the metal a little bit and I was wondering if I ran a bead down it would it be alright? The part is a piece of angle iron that is being used on some stairs.
Mike926443
New Member
 
Posts: 3
Joined: Wed Apr 06, 2016 2:53 pm

Re: Grinding

Postby weldin mike 27 » Sun May 14, 2017 7:32 pm

Yep, pad it up and dress it off again. I do it all the time.
User avatar
weldin mike 27
Weldmonger
 
Posts: 3276
Joined: Fri Apr 01, 2011 10:59 pm
Location: Australia; Victoria

Re: Grinding

Postby Olivero » Mon May 15, 2017 11:13 am

Yeah, no worries. Might have to redrill it, use a grinding wheel this time.
if there's a welder, there's a way
User avatar
Olivero
Ace
 
Posts: 382
Joined: Tue Dec 13, 2016 9:24 pm
Location: Clearwater Florida


Return to Welding Forum General Shop Talk