Re: Crack repair failure??
Posted: Tue Aug 22, 2017 9:11 pm
I would lean towards stick or tig as well.
The Forum
https://forum.weldingtipsandtricks.com/
https://forum.weldingtipsandtricks.com/viewtopic.php?f=2&t=12186
Very good question! It's a chart you see a lot online on blacksmith forums and such. The page does use kilograms and cubic metres. Perhaps a page from a US military training/reference book or Canadian/EU of origin. Don't find much other references though..MarkL wrote:Arno, what book is that chart from?Arno wrote:As you grind out the part, do a spark-test on the clean base material at the same time to see if it's perhaps a high(er) carbon material.