space or bevel
Posted: Wed Nov 15, 2017 4:57 pm
I am wanting to weld a 1/2" thick plate(flat stock)to the open end of a 6" pipe(5/16"wall) using 1/8" 6011. Do I need to bevel the pipe,space between pipe and plate or both ? Thanks!
Welding Tips and Tricks
The Forum
https://forum.weldingtipsandtricks.com/
space or bevel
https://forum.weldingtipsandtricks.com/viewtopic.php?f=2&t=12523
Page 1 of 1
Re: space or bevel
Posted: Wed Nov 15, 2017 9:25 pm
Bevel the pipe and have a gap. You'll need a root face as well, make the gap the same as the root face
Re: space or bevel
Posted: Thu Nov 16, 2017 8:12 am
If you mean like this picture, I'd just set the pipe on flat and weld it.
- image.jpeg (21.48 KiB) Viewed 837 times
Re: space or bevel
Posted: Thu Nov 16, 2017 8:54 am
what are you going to do with it?
craig
craig
Re: space or bevel
Posted: Thu Nov 16, 2017 5:23 pm
I’m with Craig. Both of the other answers are correct, depending on pipe thickness and how you plan on stressing the finished product.
Re: space or bevel
Posted: Thu Nov 16, 2017 10:57 pm
NO!!Poland308 wrote:I’m with Craig. Both of the other answers are correct, depending on pipe thickness and how you plan on stressing the finished product.
lol- there can be only one.jpg (11.03 KiB) Viewed 808 times
Re: space or bevel
Posted: Thu Nov 16, 2017 11:44 pm
One right answer for each variable.
Re: space or bevel
Posted: Fri Nov 17, 2017 12:27 pm
Thanks to all that replied. What I’m making is an adapter for a vibrahammer on a skid steer to drive 4 1/2” O.D.pipe. The wall thickness of the 6” pipe adapter is 5/16” I will weld it to the 1/2” plate and then weld a short 4” piece of 2 3/8”> .250 wall to the 1/2” plate that will go inside the cup of the hammer. Thanks