)Yes over-clamped, but not enough clamps is not enough clamps.
I bought two, so I can use them side-by-side as a 4 x 6, but when I don't need that much area, I can just use one as a 3 x 4.
Don't ask me a bunch of questions! (Ruark, circa April 2022 )
Yes over-clamped, but not enough clamps is not enough clamps.
I bought two, so I can use them side-by-side as a 4 x 6, but when I don't need that much area, I can just use one as a 3 x 4.
)Yes over-clamped, but not enough clamps is not enough clamps.
I bought two, so I can use them side-by-side as a 4 x 6, but when I don't need that much area, I can just use one as a 3 x 4.
Still working on making the stand, but the tables are done. I have about ±0.008 per 12" on the diagonal, which was the worse offender; there were two "bumps" that were quite difficult to get minimize. Along the 4ft lengths, it is better than that, and the short 3ft sides even better, by about 0.001" less. Better than the manufacturer spec of 0.015" per 12". I only tacked the slats on the underside (along the entire lengths), not the top where the tab-and-slot meet. I didn't want to risk having those warp it since I'm satisfied with how the flatness turned out.
