It is currently Wed Aug 23, 2017 5:23 pm Advanced search

grinders

Comments & questions on new & past videos

Re: grinders

Postby Otto Nobedder » Wed Aug 02, 2017 7:48 pm

MosquitoMoto wrote:Mmm....grinders. My 2 cents:

1) Own several, one for cup brush, one for slice wheel, one flap disc, one grind wheel, etc. So much faster to just pick up another grinder than to always be changing wheels.

2) When you buy it, tear it apart and grease it. You'd be surprised how many have either very little grease or just terrible grease as standard.

3) Get a good face shield. I use a Bolle shield and wouldn't be without it. An exploding wheel in the face is even worse than a piece of twist wire in the eye. Both are nasty.

4) Respect them. You get bitten when you get complacent. (Ask me how I know!)



Moz


Also, run a new grinder a full minute with no load. This will seat the brushes to the commutator and will add lifespan. Many manuals actually tell you this, but most of us just throw a wheel on and go to work.

Steve
User avatar
Otto Nobedder
Weldmonger
 
Posts: 8364
Joined: Thu Jan 06, 2011 11:40 pm
Location: Near New Orleans

Re: grinders

Postby AndersK » Thu Aug 03, 2017 3:01 am

Otto Nobedder wrote:Also, run a new grinder a full minute with no load.


...and run them 30s without load after being used hard.
Cools the motor and add lifespan too
User avatar
AndersK
Weldmonger
 
Posts: 627
Joined: Sat Mar 30, 2013 11:49 am
Location: Sweden

Previous

Return to Video Discussion