Comments & questions on new & past videos
User avatar

http://www.weldingtipsandtricks.com/mig ... -tips.html

I know I have done a similar version of this before, but tried to make it better this time. there is always a new wrinkle.

jody

snyKGd4T-Zg
User avatar
  • Posts:
  • Joined:
    Fri Apr 01, 2011 10:59 pm
  • Location:
    Australia; Victoria

When I was training for vertical ups, we toyed with the idea of turning the wire speed down to a point where the crackle stopped and it was almost a hiss.This allowed the volts to burn in without putting too much metal into the joint. You have to be careful of undercut though.

Mick
Post Reply