Welcome to the community! Tell us about yourself, your welding interests, skills, specialties, equipment, etc.
Post Reply
DrivenToMake
  • Posts:
  • Joined:
    Wed Jul 19, 2017 1:42 pm
  • Location:
    Phoenix

Hey all. New on this board. I'm a beginner/hobbyist. Have a few shop improvement type projects under my belt with a MIG. Just picked up a small DC TIG and have been practicing on scrap pieces and have really enjoyed that.

None of my friends are into fabrication of any kind, so I'm also looking for some guys to connect and collaborate with.

Jody, if you happen to read this, my wife blames you for my welding addiction.

See ya 'round!
Mike
  • Posts:
  • Joined:
    Mon Dec 06, 2010 1:09 pm
  • Location:
    Andover, Ohio

Welcome to the forum.
M J Mauer Andover, Ohio

Linoln A/C 225
Everlast PA 200
Skid
  • Posts:
  • Joined:
    Tue Jul 18, 2017 5:48 pm
  • Location:
    Paulden, AZ

Welcome and keep on "tiggin" !
To invent, all you need is a pile of junk and a good imagination....!
Mark Twain
Post Reply