Stick Welding Tips, Certification tests, machines, projects
olek
  • Posts:
  • Joined:
    Sat Jun 03, 2017 4:07 pm
  • Location:
    France

That video, while quite old, is one of the best I have seen up to date (particularly because it is not long but all the parameters are covered very well, with some exageration indeed but after welding a little you get the point easily)





Way better than that this funny advertising for a school where, may be because in NZ (at the opposite of me) he see the result of angling the stick at reverse than what I think. ;)



A comment on that old one : they take in account the eventuality of arc blow , I rarely have seen demonstrations done that way .

Is it because they think heavy steel pieces, where arc blow can be more annoying ? Or modern equipment less sensitive to arc blow (I dont think so)

Anyway I more or less naturally raise my angle in the middle of a flat piece, welding around 85° to avoid too fat bead (since I was said I give too much "meat" to my beads)
Pianos , restorer and tuner
Dedicated to learn welding since april
slowly learning ;) not complaining of doing beads and beads
pro inverter PROGYS 200 FV PFC CEL+tig lift
OA Oxyflam 1000 cutting and welding gas torch
Post Reply