Tig welding tips, questions, equipment, applications, instructions, techniques, tig welding machines, troubleshooting tig welding process
AKTwelder
  • Posts:
  • Joined:
    Sat Apr 08, 2017 4:07 pm

20170705_182736.jpg
20170705_182736.jpg (20.75 KiB) Viewed 632 times
20170705_182721.jpg
20170705_182721.jpg (21.12 KiB) Viewed 632 times
Hello,

I am trying to get my Everlast PA200st setup to run in its Lift TIG mode for the first time, and I need some help finding what goes from the flowmeter to the attachment coming from the TIG torch pictured above. All the gas hoses I have seen online have the 2 threaded male ends, which will fit my flowmeter, but not the attachment you can see in the picture.
Is it a quick connect plug? Or do I need a hose with open ends to go between the flowmeter and the torch that will get a hose clamp at each end?

Thanks for helping a noob out.
Attachments
20170705_182804.jpg
20170705_182804.jpg (20.2 KiB) Viewed 632 times
Mike
  • Posts:
  • Joined:
    Mon Dec 06, 2010 1:09 pm
  • Location:
    Andover, Ohio

Welcome to the forum.
M J Mauer Andover, Ohio

Linoln A/C 225
Everlast PA 200
AKTwelder
  • Posts:
  • Joined:
    Sat Apr 08, 2017 4:07 pm

Thanks man, glad to be in here.
ignatz200
  • Posts:
  • Joined:
    Wed Sep 16, 2015 2:01 pm

Yes, the connector end on the gas line is a quick disconnect. Which particular kind of quick disconnect is not to be determined from the photo on its own. Perhaps a few appropriate measurements? In any case, I'm sure your local welding supply house will be more than able to give you assistance with this. ;)
AKTwelder
  • Posts:
  • Joined:
    Sat Apr 08, 2017 4:07 pm

Thanks for the reply.

I would love to go into the welding supply shop, but their hours and my working hours line up, so I was hoping to order something online to avoid taking off work. I've looked at several online weld shot sites, and haven't seen anything that looks like it would fit. seems strange it wouldn't be a common product.

Thanks for the info
User avatar
  • Posts:
  • Joined:
    Sun Sep 22, 2013 10:14 am
  • Location:
    Minneapolis Mn 55407

Everlast 250EX
Miller 250 syncrowave
Sharp LMV Vertical Mill
Takisawa TSL-800-D Lathe
Coupla Bandsaws,Grinders,surface grinder,tool/cutter grinder
and more stuff than I deserve(Thanks Significant Other)
Post Reply