mig and flux core tips and techniques, equipment, filler metal
BooRadley
  • Posts:
  • Joined:
    Thu Jun 03, 2010 2:07 am

I will be welding (MIG) up some 1/8" mild steel soon for a test. 2f and 3f positions. It's been a little while since I MIG welded, and I don't have access to a MIG welder at this time. Please tell me, what voltage setting and wire speed setting do you recommend starting at? (I know to experiment a bit to see what works best, I just need a very good starting point).

Thanks.
Sarge

Assuming solid wire and gas... .035? If so, I like to go a little slower on a test and would likely start at 19 and 195 wire speed. All depends on your welding style. :shock:
Be Innovative.
Goal is perfection, but excellence is Acceptable.
Powermig 255C
Powermig 350MP x2
175 squarewave
Weld-pac 100
Hypertherm 600
Hypertherm 1250
BooRadley
  • Posts:
  • Joined:
    Thu Jun 03, 2010 2:07 am

Thanks, Sarge. That is very helpful information. Yes, it will likely be 035. Also solid wire and gas. CO2, I think? Been awhile.


Steph
User avatar
  • Posts:
  • Joined:
    Fri Nov 04, 2011 11:31 pm
  • Location:
    Toronto

I'm sure your job is done by now, but for the future, I think that this welding calculator link might be very helpful for you.
Post Reply