On these fillet welds, is it best to start in the middle and work out or start on the outside and work in? Or do you just make one continuous weld? Or does it make any difference?
Sent from my iPhone using Tapatalk Pro
- 5th Street Fab
-
Guide
-
Posts:
-
Joined:Sun Jan 15, 2017 1:08 am
The center is the thickest part so it'd be better not to start there. I usually weld from one end to the other.Bellaireroad wrote:On these fillet welds, is it best to start in the middle and work out or start on the outside and work in? Or do you just make one continuous weld? Or does it make any difference?
Sent from my iPhone using Tapatalk Pro
Sent from my XT1635-01 using Tapatalk
Bellaireroad
- Bellaireroad
-
New Member
-
Posts:
-
Joined:Wed Oct 11, 2017 12:16 am
Thanks
Sent from my iPhone using Tapatalk Pro
Sent from my iPhone using Tapatalk Pro