- 3D CAD
- ViseBenchClamp.jpg (11.23 KiB) Viewed 682 times
This vise base is made from 2x3x 3/8" angle and 3/8" plate. The mounting plate is 6x6" and the opening is about 3 1/4" to fit my 3" square tube welding table. The dual clamp rods 5/8 - 11 threaded rod with contact pads. Yes, of course there are roller thrust bearings under the contact pads, 2100 pound rated, each.
- Attachments
-
- GrizzlyVise5.jpg (62.63 KiB) Viewed 682 times
-
- Dual clamp rods
- GrizzlyVise4.jpg (45.03 KiB) Viewed 682 times
Thermal Arc Ultraflex 350 Pulse
Thermal Arc Feeder HMC-410
Thermal Arc ArcMaster 400MSTP
Thermal Arc Feeder HMC-410
Thermal Arc ArcMaster 400MSTP
- MosquitoMoto
-
Weldmonger
-
Posts:
-
Joined:Sat Aug 01, 2015 8:38 am
-
Location:The Land Down Under
Nice. Neat shop, too. I can almost smell the clean!
Kym
Kym
exnailpounder
- exnailpounder
-
Weldmonger
-
Posts:
-
Joined:Thu Dec 25, 2014 9:25 am
-
Location:near Chicago
A welding table with nice paint too...somebody has too much free timePoland308 wrote:Good idea! But I've never owned a vice with such a nice paint job.
Ifyoucantellmewhatthissaysiwillbuyyouabeer.
I did, when it was brand new, lasted about 2 minutes, , , ,Poland308 wrote:Good idea! But I've never owned a vice with such a nice paint job.
Just like when we got a new piece of heavy equipment, "I scratched the paint on that one"
-c-
Look! a hole in the space-time continuum!