New project: wheels on a weight tree
Posted: Mon Sep 04, 2017 10:39 pm
We have a weight tree that we wanted wheels on. The 2x4 first try collapsed after a few months. So of course I pulled out the Hobart Handler 120, some scrap 'u' channel from the local supply store and go for it.
Here is the original
Cut in half, the 'u' channel needed a little cleaning and cutouts for wheel travel.
Added some spacers for more clearance.
Then the wheels.
Then attached the two caster bases. This was my first time stacking beads and learning about the limited duty cycle of my little machine.
The finished project also has a little angle iron sticking out of the top to hold our clips.
Unfortunately, as I changed out my 75/25 tank at the end I blew out the valve and will need to have it rebuilt. All in all, I'm feeling more comfortable with various thicknesses and basic fabrication concepts. I know there was probably an easier way to do this, but it's what made sense with what I had and $21 in scrap. I might paint it all later, but I live in Phoenix, so moisture and rust aren't a big concern.
Feedback is appreciated
Here is the original
- IMG_1348.JPG (62.76 KiB) Viewed 1540 times
- IMG_1349.JPG (55.49 KiB) Viewed 1548 times
- IMG_1351.JPG (37.35 KiB) Viewed 1548 times
- IMG_1352.JPG (41.17 KiB) Viewed 1548 times
- IMG_1353.JPG (51.71 KiB) Viewed 1548 times
- IMG_1354.JPG (59.93 KiB) Viewed 1548 times
- IMG_1358.JPG (48.89 KiB) Viewed 1548 times
Feedback is appreciated