[Stew]

Before and after paint, a bench vise stand.
At the time I didn't have a work bench to mount my new vise on.



Sent from my SM-G960W using Tapatalk

[JayWal]

Looks great, nice welds.

How did you weld onto the brake drum? First time I did that it cracked like an egg. I blessed it with some colorful language and redid it all with some 308L stick electrodes.

Sent from my SM-G970W using Tapatalk

[Stew]

All mig, I setup for the thickness of the bottom of the rotor.
I made a second stand for a used bench grinder but the rotor was below freezing when I welded it so lots of cracks showed up in the weld. Lesson learned.

Sent from my SM-G960W using Tapatalk

[LtBadd]

Looks good!

[Stew]

Here are the photos of the finished bench grinder stand, same design just different height and bolt hole pattern.

Sent from my SM-G960W using Tapatalk