[gurew]

i have about 5 months total welding experience, id say that my welding skills have gotten really good, really fast...im going to stick to this for making a living now...





some tricky aluminum welding... -4 AN weld fitting to a -6 AN aluminum fuel tube piece







and finally some 308 stainless sch40 pipe, 3/32 tungsten, runners are 56amp single pass with 1/32 filler on the runners and collectors, 6 beads at a time

then on the flange its 2 passes at 200 amps, 6 beads at a time. now my cup size is huge, i use the ck gas saver with clear lense...they break easy but damn its such a nice cup to have, low profile and very very wide...lots of coverage to get the deep colors

[rick_barter]

Nice welds. Is that a Synchrowave 250? What size breaker are you running it off of?