What welding projects are you working on? Are you proud of something you built?
How about posting some pics so other welders can get some ideas?
rahtreelimbs
  • Posts:
  • Joined:
    Mon Jun 14, 2010 10:39 pm

So I took the solid top off of my welding table and converted it to a slatted design. I like how it turned out. I managed to get the table level along the horizontal supports within about .050". Then I went diagonal......one way is level the other shows about 3/32" or so gap. If I tried to level that gap then the others are thrown off. I did shim it and had it leveled better but after the small welds I used some gaps showed. It's good enough for my purposes. I think the only way to get a perfect level table is to use brandish grinder. Pics next post.
rahtreelimbs
  • Posts:
  • Joined:
    Mon Jun 14, 2010 10:39 pm

Image
rahtreelimbs
  • Posts:
  • Joined:
    Mon Jun 14, 2010 10:39 pm

Image
rahtreelimbs
  • Posts:
  • Joined:
    Mon Jun 14, 2010 10:39 pm

Image
Rick_H
  • Posts:
  • Joined:
    Sat Feb 08, 2014 1:50 pm
  • Location:
    PA/MD

Looks nice!
I weld stainless, stainless and more stainless...Food Industry, sanitary process piping, vessels, whatever is needed, I like to make stuff.
ASME IX, AWS 17.1, D1.1
Instagram #RNHFAB
exnailpounder
  • Posts:
  • Joined:
    Thu Dec 25, 2014 9:25 am
  • Location:
    near Chicago

Rick_H wrote:Looks nice!
PS....your shop is too clean :lol:
Ifyoucantellmewhatthissaysiwillbuyyouabeer.
Post Reply