Ideas & suggestions for videos
Post Reply
Jamie1968
  • Posts:
  • Joined:
    Tue Feb 02, 2016 2:47 pm

Hi,
New here. But have been watching the videos on You Tube for a while now. Very good stuff...
I have a request/suggestion for a video that I don't think has been covered yet. I would like to see a tutorial on base metal repair on a pump or motor shaft. I am a machinist by trade, and have picked up some welding knowledge over the years.
But this is an area that I can't really seem to get much information on. Most welders I have spoken to about it, don't really have a technique, but surely there has to be something to it in order to ensure that you get penetration, no porosity, and ultimately control warpage. If there is anything that could be shown, I would appreciate it.
Keep up the good work!
User avatar
  • Posts:
  • Joined:
    Thu Jan 06, 2011 11:40 pm
  • Location:
    Near New Orleans

Welcome Jamie,

I'm going to copy this post to "Wish List", which is specifically for making video suggestions, but there are two videos right here on the first page of "Video Discussion" that apply to some degree to your question. I expect others will share more of them. Check out these topics:

http://forum.weldingtipsandtricks.com/v ... =23&t=8542
http://forum.weldingtipsandtricks.com/v ... =23&t=8491

Steve S
User avatar
  • Posts:
  • Joined:
    Mon Nov 04, 2013 7:51 am
  • Location:
    The Netherlands

Adam Booth (ABOM79 on Youtube) has done several video's on shaft repairs and buildups. Often he does use spray-metal transfer like in this video:

https://www.youtube.com/watch?v=KK9OwDxwJp4

Keeps the heat input low, so less warpage but AFAIK not suited for building up severe damage/wear.

He also did a few repairs and buildups with machining afterwards with more traditional TIG buildup and then machining it back down while keeping warpage in check. May want to search through some of his video's.

Bye, Arno.
Post Reply