A dedicated area for reviews, thoughts, and feedback on shop/welding products
Post Reply
raul.j.granado
  • Posts:
  • Joined:
    Wed Feb 01, 2017 1:30 am
  • Location:
    Shandon, CA

Hello, First of all thank you for allowing me to be apart of this community of professionals. So I guessed my question would be well suited under this topic, if it isn't please direct me in the proper direction. So I here is my question. Does any one have a good part number for a 14 pin foot control that will work on a Thermal Arc 300-LM DC Inverter welder? I am havng a hard time finding one on the old interwebs. If anyone has a website URL that would be much appreciated as well. Thanks
User avatar
  • Posts:
  • Joined:
    Sun Oct 27, 2013 10:57 pm
  • Location:
    Big Lake/Monticello MN, U.S.A.

Pretty sure that may be a Miller 14 pin connection.

Check out ssc foot controls - they work really good and they have a chart that lists all the models.

If it's not on the list, contact them and they will hook you up.
Dave J.

Beware of false knowledge; it is more dangerous than ignorance. ~George Bernard Shaw~

Syncro 350
Invertec v250-s
Thermal Arc 161 and 300
MM210
Dialarc
Tried being normal once, didn't take....I think it was a Tuesday.
Poland308
  • Posts:
  • Joined:
    Thu Sep 10, 2015 8:45 pm
  • Location:
    Iowa

Pretty sure I found a number once on the CK website. I was looking for a replacement thumb control for my TA 186. Thinking the site listed numbers for the 6 pin and the 14 pin. I did find a place on EBay that was selling just the bare connectors but that was about a year ago.
I have more questions than answers

Josh
Poland308
  • Posts:
  • Joined:
    Thu Sep 10, 2015 8:45 pm
  • Location:
    Iowa

http://www.ebay.com/itm/Male-14-Pin-Plu ... SwrklVLbKt

I think Dave was right they might be the same.
I have more questions than answers

Josh
Post Reply