[jtybt]

Just got my first gas lens and it seems basically just a micro mesh screen. I went to the store and found a ladle with a micro mesh SS screen, cut it out and stuck it in a #7 cup(#26 torch). Will it work?

[admin]

if you do it right and cut the screen just the right size where it will wedge and fit snugly in the cup, it will work.

here is a page where i did it with a #12 cup on a wp20 torch...


http://www.weldingtipsandtricks.com/wel ... nless.html

good luck,

jody

[jtybt]

Thanks Jody. I just cut out and fit it last night. I wasn't sure if I needed the larger lens style cup or the smaller cup would work.

I'm going to do some practicing as soon as the rain stops.